Once you have built your own outdoor storage shed, using professional woodworking diy plans or blueprints, you will need to maneuver your equipment, tools and other items easily into the outdoor storage shed without putting a strain on your back. Building shed ramps using woodwirking diy plans is just what you need and this shed ramp needs to be built correctly so that your ramp does not collapse under the weight of you and your tools and equipment.
There are many different woodworking diy plans or blueprints for building shed ramps some of which are free and some that are not. Whatever you decide on, you need to make sure that the woodworking diy plans are descriptive enough and provide step by step instructions on building shed ramps. Professionally prepared woodworking diy plans are usually the best way to go because they provide all the information that you need including the materials and tools that you need as well as the size to cut the wood pieces for building shed ramps. Free plans are usually not as detailed and usually end up costing you additional time and money.
Building Shed Ramps - Points to Consider
Following woodworking DIY plans when building shed ramps, the incline of the roof should be about 3 inches per vertical foot. Anything steeper than this will end up causing problems. It is important that the storage ramp have enough of a slope but one that is not too steep.
When building shed ramps with woodworking diy plans, the ramp should also be sturdy enough to be able to handle any amount of weight that it shall be subjected to. You do not want to keep fixing the storage shed ramp or building a new storage shed ramp because it was not build sturdy enough especially if you have heavy equipment.
A good set of woodworking diy plans should be able to provide you with a list of the type wood to use when building shed ramps that will be sturdy enough for your purposes.
At a minimum, you can use 4 x 4 inch of pressure treated lumber for the framing of the storage shed ramp that is set at no more that 12 inches apart. You would then use 3/4 inch plywood that has been pressure treated for the storage shed ramp surface. In order to prevent slipping when the storage shed ramp is wet, it is beneficial to either use non skid or real rubber on the surface of the ramp. Woodworking diy plans will go into greater detail on this and offer other suggestions when building shed ramps.
You could also purchase metal storage shed ramps if you prefer but they may be very expensive and it would be cheaper for you to build one made of wood from scratch using woodworking diy plans. A wood storage shed ramp is just as effective and safe as a metal shed ramp.
If you will be driving some type of vehicle into the shed, some type of ramp system is needed. In addition, if the foundation lifts the shed more than a foot above the ground, a sloped walkway or ramp will be beneficial to prevent pressure and damage to your knees. Woodworking diy plans on building shed plans discuss this in greater detail to help you make the right decision when building shed ramps.